These pages will give you an idea of what you can
do with an older spa. The following spa retro-fits were done using the
Gecko Pro-Pack.
The
following pictures are from a customers installation progress as he worked on
and re-configured the spa control for a Pacific Marquis spa...
Overall View of
this Pacific Marquis Spa,
(this beautiful spa was purchased
-dead- for $300.00).
Original
Pacific Marquis side control
panel for this
spa.
This
shows the initial configuration before the installation of the spa pack.
A new Vico style spa pump was installed, (with the green rebuilt motor).
This particular Pacific Marquis spa has two spa pumps, and no blower, so the
Pro-Pack is ideal for this installation. The pre-existing service valves
allow for removal of the pack for service or heater element replacement if
necessary, without draining the spa.
Installation
almost complete. At this point the customer was going to replace the
Valterra slicer valve at the suction side of the pump. Note that the spa
pack was only held in place by the plumbing. At last contact, this
customer was enjoying his newly configured spa, and was looking to replace pump
number 2; with a side discharge pump such as a 1.5" Vico or
Aqua-Flo.
